Product support 5 min read

MultyC

MultyC is BioLogic’s user-friendly software used for the control of the MCS 10 system. This easy-to-use software is compatible with Windows XP, 7, 8 and 10.

The MultyC software provided with the MCS 10 system controls both the MCM 10 and WTSH 10 units for conductivity measurements.

Calibration protocol for conductivity cells

A cell calibration routine is available to automatically calculate the constant of the conductivity cell using a standard solution. Up to ten cells can be calibrated at the same time. The new cell constant can be stored automatically in an experimental setup.

Customized experimental setup

Experiment Setup including cell constants (for up to 10 cells) can be created and saved by the user. The Experiment Setup window also allows a custom ID to be entered for each channel.

Two temperature control modes

The MultyC software offers two ways to program the temperature map: Sequencer and cycler modes.
– Sequencer: the most flexible mode to program a custom linear temperature sweep.
– Cycler: It allows temperature ramp up and ramp down with a single temperature step value and temperature soak value

Data processing

MultyC allows data to be exported to csv and fra formats, both of which are compatible with EC-Lab and MT-Lab. Analyzing data in EC-Lab or MT-Lab allows the use of “ZFit”, a powerful data-fitting tool.

Features

• Multiple measurements
• Temperature control
• Cell calibration procedure
• Exporting data to csv and fra formats

Downloads