You searched for BluRev Rotating Disk and Ring-Disk Electrode (RDE/RRDE)

This application note shows the various relationships and methods needed to extract the diffusion coefficient of an inserted species into a host electrodes using Electrochemical Impedance Spectroscopy (EIS), Potentiostatic Intermittent Titermittent Technique (PITT) and Galvanostatic Intermittent Titration technique (GITT). The main results are that when the system is composed of several charge transfer resistances and double layer capacitances, only EIS can simply lead to the diffusion time constants and hence diffusion coefficients.

Equivalent model of electrochemical cell inc. ref. electrode impedance and potentiostat parasitics Battery – Application Note 44

AN44. EIS artifacts precautions. Electrochemistry

Protocols for studying intercalation electrodes materials- I: Galvanostatic cycling/potential limitations (GCPL) GITT Battery – Application Note 1

AN 1. GITT - Electrochemistry & Battery Application. Electrochemistry

In-situ electrochemical study of LiFePO₄ electrodes by quartz crystal microbalance Battery – Application Note 68

No description

The mystery of potentiostat stability explained (Potentiostat stability) Battery – Application Note 4

AN 4. Potentiostat stability - Electrochemistry & Battery. Electrochemistry

Calculation of the active surface of platinum (Fuel cell ECSA) Corrosion – Application Note 11

AN11 . Fuel cell ECSA - Electrochemistry.

How to interpret lower frequencies impedance in batteries (EIS low frequency diffusion) Battery – Application Note 61

AN61. EIS low frequencies diffusion - Battery. Electrochemistry

Measurements of double layer capacitance Battery & Corrosion – Application Note 21

AN21, Double layer capacitance, Electrochemistry

Using the SECM150 to Measure an NMC Battery Electrode Scanning Probes – Application Note 21

AN21. Measure an NMC Battery Electrode. Scanning probe electrochemistry

ac-SECM to investigate battery electrode materials in non-aqueous electrolyte Scanning Probes – Application Note 7

AN 7. ac-SECM to investigate battery electrode materials in non-aqueous electrolyte. Scanning Probe Electrochemistry.

Investigation of an interdigitated array electrode using ic-SECM Scanning Probes – Application Note 13

AN13. Investigation of an interdigitated array electrode using ic-SECM.. Scanning probe electrochemistry

An advanced EPR stopped-flow apparatus based on a dielectric ring resonator

CITATION: Günter Lassmann, Peter Paul Schmidt, WolfgangLubitz

Corrosion current measurement for an iron electrode in an acid solution (Tafel plot LPR) Corrosion – Application Note 10

AN10. Tafel plot LPR - Corrosion. Electrochemistry

Protocols for intercalation electrodes materials-2, Potentiodynamic Cycling/Galvanostatic Acceleration (PCGA) PITT Battery – Application Note 2

AN 2. PITT - Electrochemistry & Battery. Electrochemistry

Electrochemical Noise Measurements Part III: Determination of the noise resistance R_n Corrosion – Application Note 39-3

AN 39-3. Electrochemical noise measurement ENA ASTM #3. Electrochemistry

Battery cycling with reference electrodes using the PAT-cell test cell Battery – Application Note 58

AN58. Reference electrode. Electrochemistry

Introduction to the Modular Map Experiment: an Interdigitated Array electrode example Scanning Probes – Application Note 14

AN 14. Introduction to the Modular Map Experiment: an Interdigitated Array electrode example. Scanning Probe Electrochemistry.

Instrument & Quartz Crystal Microbalance (QCM) coupling: Mass measurement during polypyrrol film deposition Electrochemistry – Application Note 13

AN13. eQCM - Electrochemistry. Electrochemistry

Ohmic Drop Part III: Suitable use of the ZIR techniques (Ohmic drop & ZIR techniques) Battery – Application Note 29

AN29< Ohmic drop & ZIR techniques, Electrochemistry

CV Sim: Simulation of simple redox reaction (E) Part 2 Ohmic drop effect & double layer capacitance Kinetics – Application Note 41-2

AN41-2 CV simulation #2. Electrochemistry

Ohmic Drop Part I: Effect on measurements (Ohmic drop effect on measurements) Battery & Corrosion – Application Note 27

AN27 Ohmic drop effect on measurements, Electrochemistry

Staircase Potentio Electrochemical Impedance Spectroscopy (SPEIS) and automatic successive ZFit analysis Battery – Application Note 18

AN 18. EIS Zfit - Electrochemistry, Battery & corrosion. Electrochemistry

UV-Visible spectroscopy & electrochemistry coupling: Spectroelectrochemisty on polypyrrol film Electrochemisty – Application Note 12

AN12. Spectroelectrochemistry. Electrochemistry

How to check and correct non-stationary EIS measurements using EC-Lab^® (part 1) Corrosion – Application Note 69-1

How to check and correct non-stationary EIS measurements using EC-Lab®

Multi Pitting Corrosion (Pitting) Corrosion – Application Note 25

AN 25, Pitting - Corrosion, Electrochemistry

Impact of Highly Concentrated Alkaline Treatment on Mesostructured Cobalt Oxide for the Oxygen Evolution Reaction

CITATION: Eko Budiyanto, Cristina Ochoa-Hernández, and Harun Tüysüz

Electrical characterization of a ceramic with MTZ-35 and HTSH-1100 test fixture Material Science – Application Note 1

AN1. Electrical characterization of a ceramic with MTZ-35 and HTSH-1100 test fixture. Materials Science

UFS-SEC: SpectroElectrochemical Cell for UV-Vis, NIR and IR measurement Spectroelectrochemistry – Application Note 52

AN52. Spectroelectrochemistry. Electrochemistry

Inaccuracy of corrosion current determination in presence of ohmic drop Corrosion – Application Note 48

AN48. Ohmic drop - Electrochemistry & Corrosion. Electrochemistry

Electrode-Specific State of Health Diagnostics for Lithium Ion Batteries Using Cell Voltage and Expansion

CITATION: Suhak Leea, Peyman Mohtata, Jason B Siegela and Anna G Stefanopoulou

Introduction to the USB-PIO: measuring the effect of light on a live leaf Scanning Probes – Application Note 15

AN 15. Application Note 15. Scanning Probe Electrochemistry

In-situ and ex-situ comparison of the electrochemical oxidation of SO₂ on carbon supported Pt and Au catalysts

CITATION/ Benjamin H.Meekins, Anthony B.Thompson, VarshaGopal, Bahareh A.Tavakoli, Mehrabadic, Mark C.Elvingtond, Prabhu Ganesan, Ty A.Newhouse-Illigee, Adam W.Shepard, Lawrence E.Scipionie James A.Greere John C.Weissa, John W.Weidner, Héctor R.Colón-Mercadob

Measurement of electrochromic bandshift at 520 nm with real-time scatter correction at 546 nmLife Sciences – Application Note 4

AN#4 JTS, Photosynthesis Measurement of electrochromic bandshift at 520 nm with real-time scatter correction at 546 nm

Precision and Accuracy in Coulombic Efficiency Measurements (High Precision Coulometry HPC) Battery – Application Note 53

AN54. High Precision Coulometry HPC. Battery Cycling/Electrochemistry

Precautions for good impedance measurements (EIS) Battery & Electrochemistry – Application Note 5

AN5. EIS precautions - Electrochemistry & Battery. Electrochemistry

How to measure the ohmic resistance of a battery using EIS (EIS-high-frequency-internal-resistance) Battery – Application Note 62

AN62. EIS high frequencies internal resistance. Electrochemistry

Low-Cost Rapid Template-Free Synthesis of Nanoscale Zinc Spinels for Energy Storage and Electrocatalytic Applications

CITATION: Aravind Baby Baskar Senthilkumar, Prabeer Barpanda

EIS measurements on Li-ion batteries EC-Lab® software parameters adjustment (EIS optimizations) Battery – Application Note 23

AN 23, EIS optimizations, Electrochemistry